unable to run the server

[suma]

Dear Sir,

I am new to Newgenlib. I have installed Newgenlib ver 3.0. But I am unable to run server. When I double click on the batch file Its just blinking but server is not running. Please help me in this regard.

I have followed documentation as it is mentioned in the following site. (http://www.verussolutions.biz/kb/installationNew). Presently I am using windows Xp operating system.

Best Regards
Suma
Signodia PG Centre

[Verus Open Source Support]

Check the JAVA_HOME system variable, I think it might be set wrong.

On Saturday 18 February 2012 02:52 PM, suma [via NewGenLib] wrote:

Dear Sir,

I am new to Newgenlib. I have installed Newgenlib ver 3.0. But I am unable to run server. When I double click on the batch file Its just blinking but server is not running. Please help me in this regard.

I have followed documentation as it is mentioned in the following site. (http://www.verussolutions.biz/kb/installationNew). Presently I am using windows Xp operating system.

Best Regards
Suma
Signodia PG Centre

---

If you reply to this email, your message will be added to the discussion below:

http://newgenlib.2944635.n2.nabble.com/unable-to-run-the-server-tp7296567p7296567.html

To start a new topic under NewGenLib, email [hidden email]
To unsubscribe from NewGenLib, click here.
NAML

[mavicsilva]

Hi.
How do you properly shut down the server?
I just click the X button but it always give me an error message and I feel like I don't close it properly. I'm afraid that it might cause some damage to the server.

[pedroparkero]

Are you using Windows? Use Ctrl+C, then it will ask for confirmation so press 'Y' for Yes afterwards.

I'm not sure if just pressing X/close can actually do damage to the server, however. I suppose a sudden termination can make any ongoing processes unsaved so maybe using the Ctrl+C way is best.

[mavicsilva]

Thanks.

[pedroparkero]

Good day!
We subscribed to a new DSL connection and hence we have a new network setup, but now I can't get our server to run properly. It takes forever in this position:


and if it does start after many minutes all we see is this:



I do hope you can help me figure out what's wrong with our setup.